JELBETON

• Used on medium and heavy pedestrian traffic floors.

• Used as a self-leveling coating for indoor surfaces with uneven floors between 1 and 10 mm thickness.

• Can be applied to concrete, ceramic, marble, and both old and new floor surfaces.

Surface Preparation: The surface must be strong, stable, clean, and free of dust. Remove any oil, grease, or wax that could prevent proper adhesion. Clean away all loose particles and repair any surface damage. Avoid airflow in the application area to prevent drying issues. For large areas, use guides to keep the surface level and avoid unevenness.

Before applying ISONEM JELBETON leveling screed, prime the surface with ISONEM D10 LATEX. This primer helps extend the working time, improves adhesion, and reduces air bubbles. Apply ISONEM D10 LATEX undiluted with a brush at 200 mL per square meter. Start applying ISONEM JELBETON within 30 to 40 minutes after priming, while the primer is still wet and the surface is slightly tacky.

After 48 hours, it’s recommended to apply a final coat of ISONEM LIQUID GLASS to protect the surface from stains, dirt, oil, and water, depending on how the surface will be used. This protective layer can be applied using a brush, roller (synthetic epoxy), or suitable spray device, with a usage of 75-100 grams per square meter (one coat).

Preparation of Mixture: Pour 4 liters of clean water into a clean mixing bucket for every 20 kg of ISONEM JELBETON. Slowly add the material into the bucket while mixing with a low-speed mixer for 3–4 minutes until a homogeneous mixture is achieved. Let the mixture rest for about 2 minutes, then mix again for approximately 30 seconds before use.

Mixture ratio: For a 20 kg bag: 4 liters of water

Application Method: The prepared mortar is self-leveling. The thickness of the material is adjusted using a notched trowel. During setting, no water should be added. Air bubbles on the surface should be removed with a spiked roller. Sudden temperature changes in the application area should be avoided. The application should not be carried out in areas exposed to direct sunlight or wind.

PACKAGING: 20 kg Craft bag

COLOR: Yellow, red, blue, green, grey

CONSUMPTION: 2 kg/m² for 1 mm thickness (powder form)

PAINTABLE (COATABLE) AREA: 10 m² per 1 craft bag at 1 mm thickness

STORAGE TEMPERATURE (°C): 5 - 35 °C

SHELF LIFE: 24 months from date of production if stored in original, unopened, undamaged packages.

STORAGE CONDITIONS: Store tightly closed in a dry and cool place.